您的位置:首页  > 论文页面

1J50软磁合金热变形微观组织演变规律研究

发表时间:2018-04-28  浏览量:987  下载量:251
全部作者: 肖刚锋,夏琴香,黄涌,程秀全
作者单位: 华南理工大学机械与汽车工程学院;广州民航职业技术学院飞机维修工程学院
摘 要: 针对1J50软磁合金室温下塑性较差、变形困难的问题,提出在高温下实现其塑性变形。通过对热拉伸后的试样进行微观组织观测,研究温度及应变速率对1J50软磁合金热变形时微观组织的影响规律,并进行热强旋成形试验验证。结果表明,1J50软磁合金在800℃和900℃时发生动态再结晶,生成了等轴状晶粒;在变形温度为800~900℃、应变速率为0.01~1 s-1变形时,动态再结晶较为充分,有利于塑性变形;热强旋可顺利实现1J50软磁合金筒形件的塑性成形。
关 键 词: 机械制造工艺与设备;微观组织演变;热变形;1J50软磁合金;变形温度;应变速率
Title: Research on the microstructural evolution of 1J50 soft magnetically alloy during hot plastic deformation
Author: XIAO Gangfeng, XIA Qinxiang, HUANG Yong, CHENG Xiuquan
Organization: School of Mechanical and Automotive Engineering, South China University of Technology; Aircraft Maintenance Engineering Collgeg, Guangzhou Civil Aviation College
Abstract: To overcome the defects of poor plasticity and difficult deformation, hot plastic deformation was put forward. The microstructural observation of the samples after hot-tension test was carried out, and the influence of the deformation temperature and strain rate on microstructure was researched, and the rationality of the results were verified by the hot power spinning. The results show that the dynamic recrystallize is took place of the deformation temperature at 800℃ and 900℃, and the equiaxial grains are generated. The dynamic recrystallize is completed when the deformation temperature is 800-900℃ and the strain rate is 0.01-1 s1, which is beneficial for plastic forming. The experimental result shows that the hot power spinning can be carried out successfully to realize the plastic forming of 1J50 soft magnetically alloy.
Key words: technology and equipment of machinery manufacture; microstructural evolution; hot plastic deformation; 1J50 soft magnetically alloy; deformation temperature; strain rate
发表期数: 2018年4月第8期
引用格式: 肖刚锋,夏琴香,黄涌,等. 1J50软磁合金热变形微观组织演变规律研究[J]. 中国科技论文在线精品论文,2018,11(8):746-752.
 
1 评论数 0
暂无评论
友情链接